|Plugs into 120VAC but the LED driver converts the voltage to a water safe 36VDC.
|DockPro 6200 LED Dock Light
|Notice: This light uses high intensity LEDs and Must Be Submerged In Water during use.
|The DockPro 6200 is a high intensity light that will illuminate
a 12 ft to 30 ft radius of water. The actual spread of light
will be determined by water depth and water clarity
|GE Digital Timer
"With built in Photo Cell"
|Great for Docks - Slips - Piers
|Sit it on the Bottom
Hang it from the Side
"Replacement Top Lens"
|Double Lens for easy
replacement if the top
lens is damaged.
|• Aluminum Construction
• Elevated Tripod Design
• (36) High Power 3-Watt Green LEDs
• Replaceable LED Driver
• Driver Input - 120VAC
• Driver Output: 36VDC
• 65W, 1.8 amps
• 6200 Lumens of light
• Safe Low Voltage Operation
• Replaceable Lens Cover
• 50' Heavy-Duty power-cord
• Freshwater or Saltwater use
• Underwater Use Only
|Best results achieved in water 12 ft deep or less
Underwater lights are not recommended for area's that have high barnacle populations
|Courtesy of Charlie Saliba
|8:30 AM to 5:00 PM CT
Monday thru Friday
|Fishing - Docks - Flounder - Bowfishing - Shrimp
|Fishing Lights - Dock Lights - Flounder Lights
|Customer Service Hours
8:30 AM to 5:00 PM CT
Monday thru Friday
|Copyright © 2003
Fishing Lights Etc LLC
All rights Reserved
|AlumiGlo LED Lighting
|Sit It or Hang it
Legs allow the light to sit on the bottom and shine
upward. Or you can remove the legs and hang the
light over the side of your dock, pier or walkway.
Hanging the Light Off of a Dock or Pier with the Light Facing Upward.
1. Remove the top lens cover by removing the 3 plastic screws that secure it.
2. Run a 4mm nylon Cord through the center hole in the lens.
3. Tie a knot on the end of the cord so the cord can not pull back through the hole.
4. Reattach the lens using the 3 plastic screws.
CAUTION: The light MUST be submerged in water at ALL times. Please make sure
the light is low enough in the water to allow for tide changes.